A group of middle school students put on goggles and huddled around a roped-off area in Carnegie Mellon University College of Engineering to destroy the bridges they had been working on all week.

“We’re going to make Pittsburgh’s next bridges!” a student excitedly said as the first group placed its bridge in the center.

Twenty-four students spent the past four days at CMU constructing miniature bridges out of wood slats, glue and masking tape. The students created their own designs of bridges in eight groups. The only requirements were bridges had to be 32 inches in length, 6 inches in height and hold a minimum of 50 pounds. Thursday afternoon, students tested their models to see which group’s bridge could hold the most weight.

The winning team exceeded the program's expectations. Team three’s bridge reached 215 pounds without collapsing. The faculty struggled to find more weights to test its limit. At one point, Justin Haruilla, one of the instructors overseeing the project, considered standing on the bridge and adding more weights around him. Instead, team three was able to keep their bridge fully intact.

Advertise with us

The group of girls said they knew their bridge was strong but they did not expect it to hold that much weight.

“We thought that we’d do well because we knew we had a good bridge but we didn't know we were going to do that,” said Celia Vitiello, 13. “We had a drawing and it kind of went from there. We started the first day and finished yesterday.”

Her teammates, Ariana Caltagarone, 13, and Sonia Troiana, 13, believe the bridge held out because of its diagonal designs. They said other groups used vertical designs

The girls weren’t expecting to win but they each won a K’nex building set to continue their own designs.

While team three was confident in their design, other teams doubted their bridges could hold the minimum weight.

Advertise with us

When it was team two’s turn to test their project, the students were not sure if it could hold the minimum of 50 pounds. Their model not only exceeded the minimum, but it held up to 140 pounds. The students cheered excitedly when the bridge finally caved in.

“Team two I feel like I remember you guys being down on yourselves,” said Mr. Haruilla, after placing a 5 pound weight onto the group’s bridge. “You have over 100 pounds on your bridge. That’s a life lesson!”

Members of CMU Department of Mechanical Engineering placed weights, one by one, onto the wooden bridges. At 50 pounds students were able to decide if they should continue adding more weights to test the limits.

While the CMU faculty were hands-on during the destruction of bridges, they said they tried to allow students to build their bridges on their own.

“We resisted the urge to [be hands on],” said Ryan Bates, the Fabrication Manager. “We let them explore what the possibilities could be in their group. We did try to encourage a little bit more communication between the team members.”