The Pennsylvania Turnpike between Butler Valley and Allegheny Valley exits will be closed in both directions for five hours early Sunday morning for overhead bridge work.
A news release from the turnpike commission said from 11:59 p.m. Saturday through 5 a.m. Sunday, drivers exiting at these interchanges should use the following detours:
For eastbound traffic exiting at Butler Valley Interchange:
• Follow State Route 8 south (10 miles)
• Left ramp to State Route 28 north (7.5 miles)
• Exit 11 to State Route 910 east (0.2 miles)
• Left onto Freeport Road to reenter at Allegheny Valley Interchange (0.7 miles)
For westbound traffic exiting at Allegheny Valley Interchange:
• Follow Freeport Road south (0.7 miles)
• Right to State Route 910 west (0.5 miles)
• Take ramp to State Route 28 south (7.5 miles)
• Take ramp to State Route 8 north to reenter at Butler Valley Interchange (10 miles)
Alternate-route cards will be available to travelers exiting at the interchanges during the closure. Drivers should expect higher traffic volumes on detour roads during this period.
The commission said a closure will allow a contractor to finish putting up steel bridge beams for the new bridge that carries Gibsonia Road over the Turnpike. The replacement project is scheduled to be finished by late December.
Additionally, on Monday, eastbound traffic paces will occur at 10 p.m. and midnight, then again Tuesday at 7 p.m. and 9 p.m. so crews can erect structural steel and make the final connections over the eastbound lanes. During each 20-minute pace, a state police vehicle will restrict traffic to 20-25 mph through the work zone.




Comments
Welcome to Post-Gazette subscriber-only commenting community. Please review our community guidelines.