When TechMan was a callow youth, he inherited a 1955 Oldsmobile 98 from his grandmother.

Far from a sports car, it was a tank with a license plate. It seemed very advanced -- power brakes, automatic transmission, air conditioning -- but not one computer was aboard.

Today, you slide into your car seat and settle into the middle of 30 to 100 microprocessors -- little computers.

The computerization of cars began in 1977 when the Oldsmobile Toronado came out with a simple computer unit for spark-plug timing. The Cadillac Seville came out with a trip computer the next year.

Advertise with us

Most cars now have a computer-controlled throttle. Pressure on the accelerator pedal signals a control unit that analyzes engine and vehicle speed, among other factors, then signals the throttle body how much to speed up the engine.

Although Toyotas have an electronic throttle, it was a mechanical problem, friction with the pedal, not an electronic issue, that caused the recall.

In the Olds 98, each control had to have a wire connecting it to the feature it was controlling. If you had a switch for a power window in the armrest, the switch would be connected to the window motor by a wire.

Under that system, a modern car with all its gewgaws would be a tangled mass of wires, each one just waiting for its insulation to wear off and short out.

Modern cars use a system called multiplexing. A module containing at least one microprocessor handles signals from all the buttons on the door -- power windows, door locks, power mirrors, seat adjustments -- to the appropriate motor.

Advertise with us

If the button controls a device not in that door, such as the passenger-side mirror, the module send's a signal to the car's communication bus, which directs the signal to the correct motor. Thus, all connections between controls on the door and devices not on the door, require only two wires to the car's communication bus, not wires from the door switch snaking all over the car.

The most powerful computer on most cars is the engine control unit (ECU). The ECU monitors the outputs of your car (emissions, fuel economy) to manage the inputs (air intake, fuel injectors).

Using sensors that measure such things as coolant temperature and amount of oxygen in the exhaust, the ECU determines spark plug timing and how long a fuel injector is open.

All the modules in a modern car can send information on problems to the car's communications bus, which then sends it to a central module that stores it. The module can "tell" technicians with a reader device what is wrong.

In fact, in some cars it is possible to read the error codes without a professional tool.

Advertise with us

By jumping two of the pins in the diagnostic connector and then turning the ignition key to run, the "check engine" light will flash a certain pattern to indicate the number of the fault code. You can then look up the fault code at http://www.troublecodes.net/technical/.

TechMan is not recommending that you try this at home.

Computers are heavily involved in braking systems, especially on some cars like the Toyota Prius, where regenerative braking feeds excess energy from the brakes back to the car.

Computers also play a big part in ABS (anti-lock braking system). ABS helps stop wheels from locking up on braking. ABS technology has evolved into Electronic Stability Control and traction control to further improve handling.

In the recent recall of the Toyota Prius for brake problems, at fault was software that allowed a lag when the car switched from its regenerative brakes to its hydraulic brakes when the anti-lock braking system also was activated.

The next time you get into your car -- unless you've kept your Olds 98 -- think about all the computer power around you.