Question: I recently purchased a home theater system using top-rated components, and I love the sound. I am still trying to get all five of the speakers properly balanced though, and I have the feeling that I would like to achieve a little richer tone. Right now it seems tilted a little too much to the treble side of the spectrum. Is this because the speakers are new and not yet broken in, and will they mellow out in time? Any thoughts on what adjustments I might make to the Onkyo receiver to better balance the speakers?

ART DERVAES

State College

Answer: I am not there to listen to your speakers, but my gut feeling is break-in is playing a part in your current sonic shortcomings.

Advertise with us

Almost all speakers sound noticeably better after break-in, especially higher-end models such as yours.

The tweeter has very little excursion (physical movement), so there is little to break in.

The woofer and midrange drivers are much more massive and move greater distances.

Sometime playing them will loosen them up considerably and bring out their full potential.

Speaker company representatives have told me they consider break-in critical and recommend running the speakers good and hard for the first 25 to 30 hours if possible.

Advertise with us

Some speakers that use exotic technology may take even longer to sound their very best.

If you want to accelerate the process, you can put a classical music CD or action movie in your disc player, hit the repeat button, set the volume to a moderately loud level and hit play before you go to work in the morning. Obviously, if you live in a building with a shared wall like an apartment or townhouse this method may not be for you.

I love Onkyo receivers for a lot of reasons, but their Audyssey automatic setup and room equalization system isn't one of them.

If you used Audyssey to set up your system, the equalization feature may be robbing your system of some of the tonal richness. My own experience is receivers sound better without the Audyssey equalization engaged.

I'd start tweaking the system by turning Audyssey off and then balancing the speakers by ear, using test tones from the receiver's audio setup menu.

Advertise with us

If you like stronger surround effects, you can turn up the rear channels a bit louder than the main speakers when the test tones play.

To achieve an extremely accurate five-speaker balance, get a sound pressure level meter.

I recommend the analog model sold at Radio Shack for $45. Sit in the listening area and adjust each speaker's test tone to 75 dB. Not only will this give you perfect balance, but also if your volume control counts from a negative number to 0 to a positive number you can duplicate the exact volume the director intended for the theater.

The 0 setting corresponds to an exact match. The negative 3 would represent 3 decibels lower than the official theater volume, negative 10 would be 10 decibels under the theater volume, plus 3 would be 3 decibels louder, and so on.

Finally, don't forget the importance of speaker placement.

Try moving the speakers back and forth from the rear wall, and experiment with different lateral distances as well. Sometimes just a few inches can make a big difference.