The fire that risked bringing down the Liberty Bridge should not have occurred had workers been following long-standing fire safety measures, construction experts said Thursday.

Workers at all construction sites are supposed to follow standards set by the federal Occupational Safety and Health Administration and the National Fire Protection Association, including specific requirements when they are doing “hot work” such as welding or using torches to cut steel. The fire a week ago that caused a 30-foot chord to bow and put the 2,600-foot-long bridge in danger of collapsing started when sparks from a worker cutting steel ignited plastic ventilation pipe and a tarpaulin.

According to the NFPA, crews doing hot work should have any combustible material at least 35 feet away from the flame or cover it with fire-retardant material. In addition, at least one member of a hot-work crew should be assigned as a “fire watch” to check for potential problems and have fire suppression equipment such as a fire extinguisher immediately available.

OSHA has similar requirements for worker safety.

Advertise with us

“This is completely avoidable. All you have to do is follow the rules,” said Frank Burg, a registered professional safety engineer and certified safety professional in Woodstock, Ill. Mr. Burg spent 18 years as an OSHA inspector and has operated a private firm, Accident Prevention Corp., for 22 years.

“I can’t imagine how this could happen if they did everything they were supposed to do.”

Joseph B. Fay Co., the general contractor for the $80 million bridge-reconstruction project, referred questions to an outside spokeswoman, who couldn’t be reached for comment. OSHA’s area office in Pittsburgh opened an investigation of the fire Wednesday and might need up to six months to complete it.

PennDOT district executive Dan Cessna said the agency is continuing to review the fire and won’t comment while other agencies are investigating. Fay filed the required safety plan as part of its contract and PennDOT hasn’t ordered any changes as a result of the fire.

“Obviously, you learn from issues and, obviously, this has been one,” Mr. Cessna said.

Advertise with us

Another construction expert, David Gardner, said safety should be a daily priority at all construction sites, with regular meetings at least weekly to remind crews of safety procedures and note changes that occur as jobs progress. For example, cutting steel might not be part of a job until several months in, so safety procedures should be reviewed right before that work begins.

Mr. Gardner, who is based in Pittsburgh, is a civil engineering expert who specializes in construction safety for Robson Forensic in Lancaster. He said he has worked at job sites where Fay was one of the contractors and described the firm as “very safety-oriented.”

“Construction is inherently dangerous,” he said. “Sometimes you can do everything properly and [stuff] happens.

“But an accident the magnitude of this one doesn’t happen without repercussions.”

Since the fire, PennDOT has been working with the contractor, engineering consultants and experts from Carnegie Mellon and Lehigh universities to monitor the safety of the bridge and design a repair plan. Parts are being fabricated to attach a 26.5-foot steel brace on each side of the damaged chord, and jacks and possibly heat will be used to try to stretch it back to its original length, which was compressed by 1⅝ inches.

Advertise with us

Parts should begin arriving today, Mr. Cessna said, but crews have been making progress by replacing temporary bolts on the damaged chord with longer, permanent bolts.

PennDOT hopes repairs are finished so the bridge can be reopened Monday.

Fay’s reconstruction work includes deck replacement, painting, structural steel work and new signs. About 55,000 drivers use the bridge daily.

Ed Blazina: eblazina@post-gazette.com or 412-263-1470.