The Pennsylvania Department of Transportation and the Port Authority are reviewing whether all the steel braces used during last year’s rehabilitation of the Center Avenue Bridge in Emsworth meet PennDOT safety standards.
Because it’s not clear whether pieces an inspector recommended against using were installed in a support tower for the Port Authority bridge, PennDOT inspectors will pay special attention when they inspect the project in the next few weeks. A Port Authority spokesman said the bridge, which carries 21 bus trips daily, is not in a precarious condition and the special attention during the upcoming inspection is “out of an abundance of caution.”
At issue is whether contractors used bent braces that had improperly placed holes filled with plug welds, which steel suppliers sometimes use to salvage a piece of steel. Mosites Construction Co. is the general contractor on the project, which was supposed to be done to PennDOT specifications. Use of pieces with plug welds is prohibited in tension-bearing areas because heating the steel as part of the welding process creates a weak point that can crack.
The bridge reopened Dec. 22 after a year-long project to repair the steel structure and replace the concrete deck. The bridge had a 5-ton weight limit before the project and now has a 40-ton limit.
“[The braces] are not the primary, load-bearing structures,” said authority spokesman Adam Brandolph. “They are not at the part of the bridge that supports the weight of the vehicles.”
Last year, the Delaware River Bridge between Philadelphia and New Jersey was closed for seven weeks after it developed a 2-inch gap at a 60-year-old welding site. As a result PennDOT will issue a contract in April to remove more than 650 plug welds from 13 bridges across the state to prevent possible cracking.
A June 29, 2017, document obtained by the Post-Gazette shows that a quality control inspector for subcontractor Hall Industries of Ellwood City recommended rejecting four bent braces scheduled to be used as part of the $3.65 million Emsworth rehabilitation. Mr. Brandolph said Port Authority officials met with Mosites Construction Co. on Thursday and the company produced a July 6 document signed by another inspector from Hall that says the previous problem “has been investigated and is now 100 percent acceptable.”
But Mr. Brandolph said it isn’t clear and Mosites couldn’t confirm whether the braces were used despite the plug welds, repaired in some fashion or replaced. Mosites couldn’t be reached for comment and Hall declined to comment.
PennDOT’s District 11 has a contract to inspect the Emsworth bridge and nine others owned by the Port Authority and routinely inspects them within six months after a construction project. Lou Ruzzi, the district bridge engineer, said inspectors will pay special attention to whether the bent braces have plug welds.
“I want them to look for plug welds,” Mr. Ruzzi said. If plug welds are found, “we would have to see where they were at before we know whether [Port authority and the contractor] have to do anything about it.”
Ed Blazina: eblazina@post-gazette.com, 412-263-1470 or on Twitter @EdBlazina.







Comments
Welcome to Post-Gazette subscriber-only commenting community. Please review our community guidelines.