Thousands of drivers will face long detours as the Hulton Bridge closes for two weeks amid a $64.8 million replacement project.

The Pennsylvania Department of Transportation announced the closure will begin at 12:01 a.m. Thursday and continue around the clock until 11:59 p.m. on June 24. Crews will reconstruct Hulton Road at the intersection with Third Street in Oakmont and Freeport Road at the approach to the bridge in Harmar.

The posted detour from the Harmar side uses Route 910 to inbound Route 28 to reach the Highland Park Bridge, and Washington and Allegheny River boulevards to reach the Oakmont side. The detour for Oakmont traffic uses the same route in reverse.

Police will be stationed at key intersections along the detour route, PennDOT said.

Advertise with us

An alternate detour follows outbound Route 28 to the Route 366 Tarentum-New Kensington interchange, crossing the George D. Stuart (Tarentum) Bridge and following Route 366 south to Logans Ferry Road, bearing right at Coxcomb Hill Road, which becomes Hulton Road.

Motorists also can use the C.L. Schmitt Bridge, which crosses the Allegheny River from Freeport Road into downtown New Kensington.

During the closure, Freeport Road will be in an alternating one-way pattern near the bridge, with traffic controlled by temporary signals.

The 107-year-old bridge is being replaced with a four-lane span upstream from the existing structure. Portions of Freeport and Hulton roads are being realigned. A second two-week closure is expected in the fall to link the roads with the new bridge, which will open afterward.

An average of 19,000 vehicles cross the existing bridge on a typical weekday.

Jon Schmitz: jschmitz@post-gazette.com, 412-263-1868 or on Twitter @pgtraffic.