Traffic moving westbound on the Pennsylvania Turnpike between the Butler Valley and Allegheny Valley interchanges will face delays Monday evening as supplies are brought in for construction on an overhead bridge.
State troopers will either halt traffic or move traffic through the work zone between exits 39 and 48 at a 20-25 mph pace as trucks carrying bridge beams move into place beginning about 8 p.m., said Susan Jones, media and public relations assistant for the turnpike. The process of moving the beams should take about 20 minutes, after which traffic will be allowed to flow as usual.
This is just the first step next week in the process of replacing the bridge where Route 910 crosses above the turnpike. The turnpike will be closed eastbound and westbound from midnight to 6 a.m. Sept. 21 as the beams are raised into place, Ms. Jones said.
The bridge work, which will be done by contractor Lane Construction, is part of the early action needed to accommodate the total reconstruction of the toll road from milepost 40 to 48. Ms. Jones said the project is expected to be completed by fall 2018 and cost $200 million.
Three bridges have been replaced and opened to traffic since work began in early 2013. Over the next four years, two additional bridges in the area will be replaced and the mainline will be reconstructed and widened between the Butler Valley and Allegheny Valley interchange, according to a press release.




Comments
Welcome to Post-Gazette subscriber-only commenting community. Please review our community guidelines.