Getting out on the water hasn't been an easy task this spring for area boaters.

Martha Rill, Post-Gazette

Gary Crooks of Fineview steers his pontoon boat on the Allegheny River near PNC Park so his friends can retrieve the home run ball hit by St. Louis Cardinals outfielder Jim Edmonds. It?s the time of year when area residents are putting their boats into the water for the summer.

Click photo for larger image.

Advertise with us

The weather -- It has rained every day, hasn't it? -- hasn't made for many pleasant days. Plus, storms have placed so much debris in the water that even when the sun is shining there is no sense going out on the water just to play tag with tree limbs.

"It has still been a busy time for us," said Jay Sharer, marketing director at Fox Chapel Marine. "We've been getting a lot of new boats ready and even when the river is bad a lot of people just go down and sit on their boats."

Many boaters still have their crafts on trailers because the rivers have been messy. That means they can still run down a pre-launch checklist that could keep them from having a trouble-free summer on the water.

For those who have their boats in the water and docked, it's a good idea to go over the checklist anyway. There might be something they missed.

Here are some things BoatU.S., the Boat Owners Association of the United States, recommends checking out before backing the trailer down the ramp:

Advertise with us

Inspect and lubricate seacocks. Hoses and hose clamps should be inspected and replaced if necessary.

Inspect prop (s) for dings, pitting and distortion. Make sure cotter pins are secure. Grip the prop and try moving the shaft. If it's loose, the cutlass bearing may need to be replaced.

Inspect the hull for blisters, distortions and stress cracks.

Make sure the engine intake sea strainer is free of corrosion and properly secured.

Use a hose to check for deck leaks at ports and hatches. Renew caulk or gaskets as necessary.

Advertise with us

Make sure that stern drain plug is installed.

If you have an outdrive or outboard engine, inspect rubber outdrive bellows for cracks, dried and/or deteriorated spots and replace if suspect.

Check power steering and power trim oil levels.

Inspect outer jackets of control cables. Cracks or swelling indicate corrosion and mean that the cable should be replaced

Inspect fuel lines, including fill and vent hoses, for softness, brittleness or cracking.

Advertise with us

Inspect fuel tanks, fuel pumps and filters for leaks. Clamps should be snug and free of rust. Clean fuel filters.

Inspect bilge blower hose for leaks

Clean and tighten electrical connections, especially both ends of battery cables. Wire brush battery terminals and fill cells with distilled water.

"Checking the battery is the big thing," Sharer said. "The life of a marine battery is about three to four years, so if you have one that old you might want to think about a replacement."

For sailboats with rigging, inspect fittings for cracks and rust. Inspect wire halyards and running backstays for "fishhooks" and rust.

Advertise with us

Remove tape on turnbuckles and lubricated threads. Replace old tape with fresh tape.

And don't forget the trailer.

It's a good idea to check the tire threads and sidewalls for cracks or lack of tread. Also check the air pressure in the tires and the bearings.

Bearing buddies are a good idea and should be refilled often with grease.

For those traveling any distance with their boat on a trailer, check the tail and backup lights on the trailer.

Advertise with us

When loading up the boat for the first day on the water, make sure to check the expiration date on flares and fire extinguishers, and make sure the lights on the boat are working.

"And it's not a bad idea to clean the hull off before putting it in the water," Sharer said. "There are a lot of acid-based cleaners that do a good job."

This story was originally published with images that are no longer available.