A fresh cut Christmas tree is more than just a fun holiday tradition. a fresh cut tree preserves the aroma and needles for a longer period of time than a pre-cut tree, said John McMeekin, owner of the McMeekin Christmas Tree Farm in Penn Hills.
And that is especially important this year because of the warmer weather.
“Warm days and wind dry them out sooner,” Mr. McMeekin said of commercially pre-cut trees, many of which have been cut as long as two months ago in out-of-state locations so they can be shipped to lots around the country.
A freshly cut tree will last about two months with proper watering and care, Mr. McMeekin noted.
The Department of Horticulture at Penn State University came up with a list of research-based guidelines for keeping your holiday tree fresh throughout the season.
• Use a tree stand with an adequate water-holding capacity. The stand should have a water basin that provides 1 quart of water per inch of stem diameter. For most Christmas trees, the stand should hold at least 1 gallon of water. A cut tree will absorb a surprising amount of water, particularly during the first week, so replenish the water daily.
Read More
• The tree stand should fit your tree. Some stands have circular rings at the top, so the ring must be large enough for the trunk to go through the hole. Avoid whittling down the sides of the trunk to fit a stand. The outer layers of wood are the most efficient in taking up water and should not be removed.
• If the tree is to be stored more than a couple days before display, it is advisable to place its trunk in water and store it in a cool, protected area such as an unheated garage.
• If the tree has been cut within the past 12 hours, it will not be necessary to recut the trunk prior to display indoors. If it has been longer than 12 hours since harvest, the trunk should be recut to improve water uptake.
• Cutting off a disk of wood about ¼" thick from the base of the trunk is all that is necessary before putting the tree in the stand. Make the cut perpendicular to the stem axis. Don't cut the trunk at an angle, or into a v-shape, which makes it far more difficult to hold the tree in the stand and also reduces the amount of water available to the tree.
• Keep displayed trees away from sources of heat (fireplaces, heaters, heat vents, direct sunlight). Lowering the room temperature will slow the drying process.
• The temperature of the water used to fill the stand is not important and does not affect water uptake.
• Check the stand daily to make sure that the level of water does not go below the base of the tree. With many stands, there can still be water in the stand even though the base of the tree is no longer submerged in water.
• Drilling a hole in the base of the trunk does not improve water uptake.
• The use of "I-V" type devices to supply water directly to holes drilled into the sides of the tree trunk is not as effective as displaying the tree in a more traditional, water-holding tree stands.
• Applying anti-transpirants to the tree does not have a significant effect on the rate of moisture loss. These products are marketed as a way to block evaporation from the foliage surface, but in reality they have little effect on a cut tree displayed indoors.
• Do not use any kid of additive to the tree stand. Clean water is all that is needed.
• Displaying trees in water with proper care is much more effective in reducing fire hazards than spraying trees with flame retardants. Some flame retardants can damage needles and actually increase the rate of moisture loss.
• Monitor for dryness. If needles break easily or fall off in your hand, the tree should be removed.





Comments
Welcome to Post-Gazette subscriber-only commenting community. Please review our community guidelines.