Q: I recently saw an advertisement that recommends running over fallen leaves with the lawn mower and allowing the shredded leaves to remain on the lawn. Is that really a good idea? Wouldn't that increase the amount of thatch?
A: It depends on how many leaves are on your lawn. Usually, the mower cuts leaves into small pieces that will break down quickly and not smother the grass. If you can see more grass than leaves when you are finished, it should not be a problem. However, if you have so many shredded leaves that they completely cover the grass, it's not a good idea.
The idea is that shredded leaves add some nutrients and organic matter to the soil while also keeping valuable organic matter out of the landfill.
If you have too many leaves for this to work well, you have the option of bagging them as you mow. Then you can dump the shredded leaves into a compost pile or use them as a mulch in shrub or flower borders or under trees in your yard. (It is not a good idea to do this with whole leaves because they break down very slowly. They can mat together and become almost water repellent.) Once you get the worst of the leaves cleaned up, you can mulch the remainder with the mower and leave them on your lawn.
Thatch is nothing more than a tangled mat of sloughed-off stems and roots that forms as a grass plant grows. Grass variety, soil pH (acidity or alkalinity) and your fertilization and watering practices have much more impact on thatch formation than leaving a thin layer of finely shredded leaves behind in the fall.
Late fall, after grass has stopped actively growing for the season but before the ground freezes, is an excellent time to fertilize your lawn. It may seem counterintuitive, but many plants, including grasses, put on tremendous root growth at this time of year. The typical recommendation is to apply 1 to 1 1/2 pounds of actual nitrogen per 1,000 square feet. This additional nitrogen will help the shredded leaves break down more efficiently.
To calculate how much of a given fertilizer is needed to apply 1 pound of actual nitrogen, divide 1 pound by the percentage of nitrogen in fertilizer you are using. That information can be found by looking at the three numbers found on every package of fertilizer. They indicate the percentage of nitrogen, phosphorus and potassium and are always listed in that order. For example, to apply 1 pound of actual nitrogen per 1,000 square feet if the fertilizer you are using has an analysis of 28-3-10, divide 1 by .28. The result is 3.6 pounds per 1,000 square feet.
Q. I just love red fountain grass, but I hate having to buy it every year. I have saved seed from my plants but have never been successful getting it to grow. Is there some trick I am missing?
A. Red fountain grass (Pennisetum setaceum 'Rubrum') is propagated by division rather than from seed. That explains why it is more expensive than many other annuals. Red fountain grass typically sets sterile seed, which is why you have not had any luck getting it to grow.
You can dig your plants up in the fall and pot them up in large containers to try to overwinter them indoors. An unheated attached garage or crawl space where the temperature does not fall below about 40 degrees would be ideal. Cut them back and water them thoroughly before putting them in for the winter. Leave them alone until late April. Then you can pull them out and divide the clumps if needed. Pot the divisions up to get them growing before putting them back in the garden after danger of severe frost has passed.



Comments
Welcome to Post-Gazette subscriber-only commenting community. Please review our community guidelines.