Q. I purchased an angel wing begonia last spring. I grew it in a pot on my front porch, so it was easy to take it indoors to keep it over the winter. It really did not receive enough sun -- or care -- through the winter and it looks pretty ragged. What can I do to revive it?
A. Start by trimming back any completely dead stems at the soil level. Then trim dead tips back to live growth, preferably buds or growth directed out, rather than back toward the center of the plant. If the plant is very dense, thin those remaining stems back to the sturdiest ones; remove those that are weak and spindly. Finally, remove fallen leaves and flowers from the soil to allow better air circulation and reduce the possibility of a disease starting on those old leaves and flowers.
Once the plant has been trimmed and cleaned up, you might want to repot it. You can use the same pot; just replant it in fresh potting soil. Be sure to plant it at the same depth as before. If possible, move the plant to an area where it will receive more sun, stimulating new growth. You can also start to fertilize it again. Use a water-soluble fertilizer such as Miracle-Gro, Peters', Monty's or fish emulsion, according to label directions.
When we get past the danger of frost in mid- to late May, begin putting it out in a shaded, sheltered location for a couple of hours, then take it back indoors. Repeat this daily, leaving it out longer each day, until you are leaving the plant outdoors altogether. This process of hardening off acclimates the plant to life outdoors again. It should take 10 to 14 days.
You can take the best of those live stems that you have removed and root them to create more plants, if you wish. Use clean 4-inch pots, and fill them with moistened soilless seed-starting mix. Using a soilless mix reduces the incidence of disease and creates a good environment for the cuttings to root well. Prepare the cuttings by trimming them back to 4 to 6 inches (from the tip).
Be sure to leave several sets of nodes -- the point on the stem where the leaves attach. Nodes contain undifferentiated tissue that can develop into roots or leaves, depending on their environment. Make your cut just below the lowest node you wish to keep. At least two nodes should be inserted into the rooting medium to ensure good root development. Keep two leaves above the rooting medium. Remove any leaves that will be beneath the rooting medium and any that will droop into it.
Use a pencil or a dibble to create a hole in the center of each pot. If you simply jab the cutting into the rooting medium, it may become damaged and not develop properly. You will increase your chance of success by using a rooting hormone such as Rootone (powder) or Dip 'N Grow (liquid). Dip the bottom of the cuttings (the part that will be below the rooting medium) into the rooting hormone. Gently tap off any excess and insert them into the pre-made holes. Firm the rooting medium around the cuttings for support, then water gently to settle the soil.
Place the cuttings in an area with good air circulation and bright but indirect sunlight. Once they show signs of new growth, they have rooted. Then you can start using a water-soluble fertilizer according to label directions. You can also mix the fertilizer at one-quarter strength and fertilize every time you water. As the cuttings grow, you can transplant them into larger, more decorative pots or use the angel wing begonias in combination with other annuals in beds or containers.




Comments
Welcome to Post-Gazette subscriber-only commenting community. Please review our community guidelines.