Q. I have a beautiful purple smokebush that is about 10 years old. For the first six or seven years, it produced massive smoke pods and looked beautiful. But it was growing out of control and had to be pruned. Since then, the foliage is pretty, but it does not bloom. Also, I have an Itea that no longer blooms. What is going on?
A.In both cases, it is possible that you are pruning these shrubs at the wrong time of year.
Smokebush or smoketree (Cotinus coggygria) and Itea (Itea virginica) set the current season's flower buds during the previous growing season. If you prune them too late in the season, you remove those flower buds. They will not be replaced until after the shrub would have normally bloomed. Plants that set their flower buds during the previous year are said to "bloom on old wood."
Smokebush is grown both for its attractive foliage and those airy inflorescences. The true flowers are actually insignificant; the smoky clouds of hairs that surround them are the real show. Some gardeners manage smokebush more for the foliage than for the flowers, especially the purple-leaf types. In that case, it is cut back to within 12-18 inches of the ground in late winter (mid- to late March). This practice keeps the shrub more compact and encourages the growth of extra-large and showy leaves. Smokebush makes an attractive backdrop for perennial beds when managed in this fashion. This severe type of pruning is known as stooling.
Smokebushes that are managed for their foliage in this way do not bloom. If the inflorescences are most important to you, be sure to finish any pruning by mid- to late July. This should allow the plant to set next year's flower buds while keeping it in bounds. You will be cutting short the time you have to enjoy those blooms because they remain effective from late June or early July through September. However, if you prune too late, you will not have any blooms the following year.
The same advice applies to your Itea. Prune the shrub as soon as it finishes blooming so there is ample time for it to set flower buds for next year's display.
How you prune will also affect the number and quality of flowers these plants produce. If you shear them into geometric forms, rather than allowing a more natural growth habit, you remove a higher percentage of flower buds. A more natural pruning method is to remove crowded, crossing and dead branches deep inside the shrub at their point of origin on the main stem(s). These thinning cuts permit more light to penetrate inside the shrub, which stimulates healthy new growth. If you use mostly thinning cuts late in the season, you will only remove some of the buds set to bloom next year.
Shearing also creates a dense mass of growth at the tips of branches (such cuts are known as heading back or heading cuts). Over time, repeated shearing results in an outer shell of growth with no apparent growth down inside the shrub.




Comments
Welcome to Post-Gazette subscriber-only commenting community. Please review our community guidelines.