Q: Have you either tested or used a stereo receiver that promised to up-convert analog video signals, as from a VCR? Recently I was in Best Buy looking at receivers. The kid I talked to said some receivers will up-convert all analog signals from devices that are plugged into its video inputs, while other receivers will up-convert only signals fed into the receiver's HDMI inputs. In looking at the specs for various receivers, I did notice that some receivers promise to up-convert DVD signals while others claim to up-convert "video" signals, saying, "Video up-conversion automatically converts degraded analog video signals to stable, distortion-free video." The BB kid also said he thought an old phonograph player could be plugged into the back of any receiver as long as the player's ground wire was attached to one of the screws on the back of the receiver. Do you know whether that actually works?

GORDON WALTER

Ackley, Iowa

A: I have tested receivers and other components featuring video conversion, but at the lower price points I have yet to find one that I thought improved the picture. Good video processing and conversion is expensive! In fact, unless you have a relatively expensive component (say, over $1,000) I don't even recommend using the receiver to switch analog video signals, as running the analog video signal through the receiver usually degrades it. I suggest you hook up the VCR directly to the TV's analog inputs. Switching digital video such as HDMI is different, as digital signals do not degrade as analog signals do; so if you want to run HDMI through an inexpensive receiver, that's fine.

Advertise with us

If you do have the budget for top-grade video processing, I do recommend it, especially if you have a screen larger than 55 inches. I recently tested Anthem's AVM 50 surround sound/video processor, which uses high-end video processing technology called Gennum VXP. Besides the spectacular sound quality, the processor cleaned up and improved almost every signal I fed it, including HDTV signals from my Dish Network receiver, which looked even more pure and perfect after being fed to the AVM 50. The only situation where it did not improve video was when I used it with a DVD player and an older TV that did not have HDMI inputs. In this case, the progressive scan component connection from the DVD player direct to the TV looked a bit better than the processed analog signal.

At $4,700, the Anthem AVM 50 is not for everyone, but if you are building a top-notch system and can afford it, it is well worth it. Anthem's policy of upgrading old units at a nominal cost makes it a fairly future-proof investment, as well. You can read about it at www.anthemav.com.

Onkyo has recently announced products using Realta HQV processing, a competitor to Gennum's VXP that also is well-regarded. The products are the TX-SR905 receiver and the DTC-9.8 preamp-processor from their Integra Home Theater line. You can read about them at www.onkyousa.com and www. integrahometheater.com. I have not tested them so cannot vouch for them.

Finally, to use a turntable you must have a phono input! You can add a phono preamp for $120 if the receiver does not have the proper input.