Q: I have a Panasonic DMP-BD55 Blu-ray player that I purchased because it decodes the advanced surround-sound formats and passes them to my older receiver through multichannel analog connections. This enables me to enjoy high-def Blu-ray sound without replacing my receiver.

I have two questions. First, I think a regular DVD playing on the Blu-ray player sounds better than it does when playing through my old DVD player's digital connection. Is this possible, and if so, why?

I also would like the rear surround speakers to sound a tad louder than they are now, but have not figured out how to do it yet. Can you help?

DICK DVORAK

Advertise with us

Mendota Heights, Minn.

A: When your Blu-ray player plays a DVD or Blu-ray disc, it does all of the decoding and sound balancing and sends a high-resolution analog signal from the RCA outputs. The receiver is simply a volume control and amplifier that powers the speakers. If the BD55 sounds better than your receiver, it either has a better decoding section or simply plays louder at a given volume setting on your receiver.

If the sound is a mere 1 decibel louder it will be perceived as sounding better simply because you can hear more of the recording. The "slightly louder" trick has been used to fool many people into thinking some products sound better than others, especially with expensive audio cables and speaker wire. That's why you should always conduct comparisons with volume levels exactly matched.

To change the surround balance with the Blu-ray player, you must enter its setup menus and find the section for speaker configuration. You will be able to play test tones and change the balance from speaker to speaker so the surrounds are louder. To change the balance with the other components, go into your receiver's setup menus and do the same thing.

Questions such as yours are extremely common and I have found that many systems I encounter in homes are not even close to being set up properly, even when set up by hired installers.

Advertise with us

In the interest of better sound and picture quality (and less confusion) for everyone, I recently added a setup guide to the Learning Center section of my Web site. It goes through home theater setup step-by-step, from boxed equipment to playing your first movie. Everything is explained, such as cutting and stripping the speaker wires, connecting the speakers and components, and entering the receiver and Blu-ray player setup menus to configure and balance everything perfectly.

In the first guide I use a Definitive Technology Mythos surroundbar speaker rather than five separate speakers, but the techniques work with five separate speakers as well and I point out when you need to proceed differently.

The home theater setup guide has quickly become the most popular page I have ever placed on my Web site, so I will be adding similar pages in the future.

In the coming months I will have separate guides for surround systems with multiple speakers, taping with a digital converter box, using a set-top antenna, setting up entry-level stereos and high-end stereos, even how to build a nice sounding, super low-budget system.

If you have any other suggestions, please send them along and I will try to add them to the site.